兰鹏 - 北京科技大学 - 冶金与生态工程学院

个人简介

兰鹏，男，2015年1月博士毕业于北京科技大学钢铁冶金系，获得北京科技大学第十届研究生十佳学术之星，随后留校做师资博士后。2015年7月至2016年7月于浦项工科大學开展博后工作，2017年6月聘为北京科技大学钢铁冶金系讲师。已发表论文30余篇，其中第一作者的SCI/EI检索论文近20篇，是Metallurgical and Materials Transaction A、Journal of Alloy and Compounds, Materials Characterization, Steel Research International等国际期刊的通讯审稿人。

研究领域

钢的凝固理论与应用高品质钢连铸工艺与技术大型锻造钢锭凝固质量控制先进高强高韧汽车钢设计与开发

近期论文

查看导师新发文章（温馨提示：请注意重名现象，建议点开原文通过作者单位确认）

1. Lan P, Nguyen D A, Lee S Y, et al. Heat transfer and solidification microstructure evolution of continuously cast steel by non-steady physical simulation[J]. Metals and Materials International, 2017, 23(3): 568. 2. Lan P, Zhang J. Twinning and Dynamic Strain Aging Behavior during Tensile Deformation of Fe-Mn-C TWIP Steel[J]. Materials Science and Engineering: A, 2017. 3. Lan P, Tang H, Zhang J. Hot ductility of high alloy Fe–Mn–C austenite TWIP steel[J]. Materials Science and Engineering: A, 2016, 660: 127. 4. Lan P, Tang H, Zhang J. Solidification Microstructure, Segregation, and Shrinkage of Fe-Mn-C Twinning-Induced Plasticity Steel by Simulation and Experiment[J]. Metallurgical and Materials Transactions A, 2016, 47(6): 2964. 5. Lan P, Zhang J. Thermophysical properties and solidification defects of Fe–22Mn–0.7 C TWIP steel[J]. steel research international, 2016, 87(2): 250. 6. Lan P, Zhang J. Study on the mechanical behaviors of grey iron mould by simulation and experiment[J]. Materials & Design, 2014, 53: 822. 7. Lan P, Zhang J. Strength, microstructure and chemistry of ingot mould grey iron after different cycles of low frequency high temperature loads[J]. Materials & Design, 2014, 54: 112. 8. Lan P, Zhang J. Analysis of Solidification Microstructure and Hot Ductility of Fe-Mn-C TWIP Steel[J]. Mater Sci Technol, 2014, 30(11):1297. 9. Lan P, Zhang J. Numerical Analysis of Macrosegregation and Shrinkage Porosity in Large Ingot[J]. Ironmak Steelmak, 2014, 41(8):598. 10. Lan P, Zhang J. Effect of Mould taper and Wall Thickness on Steel Ingots Soundness by 3-D Solidification Simulation[C]. The Minerals,Metals & Materials Society 2012.