Moll , Amy J. - Boise State University - Micron School of Materials Science and Engineering

个人简介

Dr. Amy J. Moll joined the College of Engineering faculty at Boise State in August, 2000. Dr. Moll received a B.S. degree in Ceramic Engineering from University of Illinois, Urbana IL, in 1987. Her M.S. and Ph.D. degrees are in Materials Science and Engineering from University of California at Berkeley, received in 1992 and 1994, respectively. Following graduate school, Dr. Moll worked for Hewlett Packard for six years in San Jose, CA, and in Colorado Springs, CO. She was an Adjunct Professor at San Jose State University and has been involved in several conferences and workshops on Materials Science and Engineering education. Dr. Moll was a co-founder of the Materials Science and Engineering department at BSU along with Dr. Bill Knowlton. She served as the first chair of the department from 2004-2008 . The Department of Materials Science and Engineering offers B.S., M.S., and M.Eng degrees as well as a minor for undergraduates.

近期论文

查看导师新发文章（温馨提示：请注意重名现象，建议点开原文通过作者单位确认）

Patrick Andersen, Mariela Bentancur, Amy Moll, and Megan Frary, "Microstructural Effects during Chemical Mechanical Planarization of Copper", Journal of the Electrochemical Society, 157, H120 (2010) S.Y. Chyung, A.J. Moll, J. Callahan, M. Frary and B. Marx, "Improving Engineering Students' Cognitive and Affective Preparedness with a Pre-Instructional E-Learning Strategy," Advances in Engineering Education, 10 (1) 22-37 (2010) D.L. Kellis, A.J. Moll and D.G. Plumlee, “Effects of silver paste application on embedded channels in low temperature co-fired ceramics”, Journal of Microelectronics and Electronic Packaging, accepted for publication (June, Volume 6) (2009). J. Jozwiak, R.G. Southwick III, V.N. Johnson, W.B. Knowlton, and A.J. Moll, “Integrating Through-Wafer Interconnects with Active Device and Circuits,” IEEE Transactions on Advanced Packaging, 31 (1) 4-13 (2008). D. Plumlee, J. Steciak, and A. Moll, “Development and Simulation of an Embedded Hydrogen Peroxide Catalyst Chamber in Low Temperature Co-fired Ceramics,” International Journal of Applied Ceramic Technology, 4 (5) 406-414 (2007). J. Youngsman, B. M. Marx, S. Wolter, J. Glass, A.J. Moll “Miniature Multi-electrode Electrochemical Cell in LTCC,” Journal of Microelectronics and Electronic Packaging, 4 (1) 31-36 (2007). K. Moeller, J. Besecker, G. Hampikian, A. Moll, D. Plumlee, J. Youngsman and J.M. Hampikian, "A prototype continuous flow polymerase chain reaction LTCC device," Materials Science Forum, 2007, Vols. 539-543, 523-528. P.A. Miranda, J. Imonigie, and A.J. Moll, “Through-Wafer Interconnect CMP: An Investigation of Slurry Interaction Effects using a Design of Experiments Approach,” Journal of the Electrochemical Society, 153 (3) G211-G217 (2006)