张靖周 - 南京航空航天大学 - 电子信息工程学院

个人简介

教育经历 1989.4 -- 1992.5南京航空学院航空发动机博士研究生毕业工学博士学位 1986.9 -- 1989.4东南大学工程热物理硕士研究生毕业工学硕士学位 1981.9 -- 1986.7清华大学内燃机大学本科毕业工学学士学位工作经历 1992.5 -- 至今南京航空航天大学科研项目 [1]超重力离心模拟与实验装置国家重大科技基础设施温控系统传热分析研究 [2]纵向项目 [3]纵向项目 [4]纵向项目 [5]纵向项目 [6]纵向项目 [7]纵向项目 [8]纵向项目 [9]纵向项目 [10]纵向项目 [11]纵向项目 [12]纵向项目 [13]纵向项目 [14]引射器流动特性试验 [15]项目开发 [16]短舱核心机舱通风冷却试验研究 [17]项目开发 [18]红外仿真及原理试验 [19]MA700飞机滑油散热器引射器设计 [20]发动机排气系统红外辐射模型试验测试授课信息传热学Ⅱ /2020-2021 /春学期 /28课时 /0.0学分 /02203390.01

近期论文

查看导师新发文章（温馨提示：请注意重名现象，建议点开原文通过作者单位确认）

[1] 张靖周,,等.Experimental investigation on convective heat transfer induced by piston-driven synthetic jet with a transmission pipe.Exp. Therm. Fluid Sci.,2019 [2] 张靖周,,等.带集气腔的脉冲射流冲击换热实验和数值研究.航空动力学报,2019 [3] 张靖周,,等.Numerical evaluation on single-row trenched-hole film cooling performances on turbine guide vane under engine-representative conditions.Numer Heat Transfer Part A Appl,2019 [4] 张靖周,,等.Numerical modeling on pumping performance of piccolo-tube multi-nozzles supersonic ejector in an oil radiator passage.Energy,2018 [5] 张靖周,,等.Experimental and numerical studies on the film cooling characteristics of anisotropic composite plates.Hangkong Dongli Xuebao,2017 [6] 张靖周,,等.Cooling and infrared radiation suppression effect of plug trailing-body of two-dimensional vector plug nozzle.Hangkong Xuebao,2017 [7] 张靖周,张靖周,张靖周等.Effect of rotation on film cooling with a single row of shaped holes on blade pressure side.JOURNAL OF THERMAL SCIENCE AND TECHNOLOGY,2017 [8] 张靖周,张靖周,张靖周等.Investigation on aerodynamic and infrared performance of a spherical convergent two-dimensional vectoring nozzle: simulating high altitude status.Hangkong Dongli Xuebao,2017 [9] 张靖周,张靖周,张靖周等.Improvement on film cooling effectiveness by a combined slot-effusion scheme.APPLIED THERMAL ENGINEERING,2017 [10] 张靖周,张靖周,张靖周等.Impingement heat transfer inside wedge-shaped concave by jets from impingment plate with front-extended port.Hangkong Dongli Xuebao,2017 [11] 张靖周,张靖周,张靖周等.Conjugate heat transfer on leading edge of a conical wall subjected to external cold flow and internal hot jet impingement from chevron nozzle - Part 1: Experimental analysis.INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER,2017 [12] 张靖周,,等.Investigation on aerodynamic and infrared characteristics of spherical convergent two-dimensional vectoring nozzle: simulating ground status.Hangkong Dongli Xuebao,2017 [13] 张靖周,张靖周,张靖周等.Composite cooling structure on rotating turbine blade.Hangkong Dongli Xuebao,2017 [14] 张靖周,张靖周,张靖周等.lConjugate heat transfer on leading edge of a conical wall subjected to external cold flow and internal hot jet impingement from chevron nozzle - Part 2: Numerical analysis.INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER,2017 [15] 张靖周.Conjugate heat transfer on leading edge of a conical wall subjected to external cold flow and internal hot jet impingement from chevron nozzle – Part 2: Numerical analysis.Int. J. Heat Mass Transf.,2017,106:339-355 [16] 张靖周,张靖周,张靖周等.Conjugated heat transfer improvement on leading edge of a conical wall using center-satellite hot-jet orifices.INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER,2018 [17] 张靖周,张靖周,张靖周等.Convective heat transfer on a flat surface induced by a vertically-oriented piezoelectric fan in the presence of cross flow.HEAT AND MASS TRANSFER,2017 [18] 张靖周,张靖周,张靖周等.Characteristics of heat transfer with dual piezoelectric fans in presence of cross flow.Hangkong Xuebao,2018 [19] 张靖周,张靖周,张靖周等.Numerical investigation of particle deposition on converging slot-hole film-cooled wall.JOURNAL OF CENTRAL SOUTH UNIVERSITY,2017 [20] 张靖周,张靖周,张靖周等.Experimental of chevron nozzle jet impingement heat transfer on flat targeting surface.Hangkong Xuebao,2018 [21] 张靖周,张靖周,张靖周等.Effects of piezoelectric fan on overall performance of air-based micro pin-fin heat sink.INTERNATIONAL JOURNAL OF THERMAL SCIENCES,2018 [22] 张靖周,Li, Xinjun,Li, Xinjun等.Characteristics of heat transfer with single piezoelectric fan.Hangkong Xuebao,2017 [23] 张靖周,张靖周,张靖周等.Experimental and numerical investigations on convective heat transfer of dual piezoelectric fans.SCIENCE CHINA-TECHNOLOGICAL SCIENCES,2018 [24] 张靖周,张靖周,张靖周等.Optimization of round-to-slot hole to improve film cooling performance.Joint Thermophys. Heat Transf. Conf.,2018 [25] 张靖周,张靖周,张靖周等.Numerical Investigation on Overall Cooling Effectiveness for a Combined Scheme of Slot Injection and Effusion Cooling.Tuijin Jishu,2018 [26] 张靖周,张靖周,张靖周等.Conjugated heat transfer on leading edge of a wedge-shaped concave wall internally impinged by hot jets from corrugated orifice plate.INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER,2017 [27] 张靖周,王鹏飞,王鹏飞等.Experiment on seal characteristics of high ratational speed of stepped labyrinth seals.Hangkong Dongli Xuebao,2017 [28] 张靖周,Lyu, Yuanwei,Lyu, Yuanwei等.Experiment of convective heat transfer of pulsed jet impingement on a flat surface.Hangkong Xuebao,2018 [29] 张靖周,张靖周,张靖周等.Experimental study on film cooling performance of imperfect holes.CHINESE JOURNAL OF AERONAUTICS,2018 [30] 张靖周,张靖周,张靖周等.Investigation on film cooling performance from a row of round-to-slot holes on flat plate.INTERNATIONAL JOURNAL OF THERMAL SCIENCES,2017 [31] 张靖周,王鹏飞,王鹏飞等.Test on heat transfer characteristics of high pressure turbine casing with active clearance control system.Hangkong Dongli Xuebao,2018 [32] 张靖周,张靖周,张靖周等.Effect of offset-jets arrangement on leading edge hot-air heating effectiveness of engine inlet guide strut.APPLIED THERMAL ENGINEERING,2018 [33] 张靖周,张靖周,张靖周等.Effects of structural parameters of effusion holes on adiabatic film cooling effectiveness over transverse corrugated surface.Hangkong Dongli Xuebao,2018 [34] 张靖周,,等.Shape-optimization of round-to-slot holes for improving film cooling effectiveness on a flat surface.HEAT AND MASS TRANSFER,2018 [35] 张靖周,张靖周,张靖周等.Numerical investigation on adiabatic film cooling effectiveness and heat transfer coefficient for effusion cooling over a transverse corrugated surface.CHINESE JOURNAL OF AERONAUTICS,2017 [36] 张靖周,张靖周,张靖周等.An investigation on convective heat transfer performance around piezoelectric fan vibration envelope in a forced channel flow.INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER,2018 [37] 张靖周,张靖周,张靖周等.Model experiment on pressure drop and thermal recovery efficiency of tandem double-U-shaped-tube heat exchangers.Hangkong Xuebao,2017 [38] 张靖周,,等.Influence of outlet delta-chevrons on aerodynamic and infrared characteristics of spherical convergent two-dimensional nozzle.Hangkong Dongli Xuebao,2017 [39] 张靖周,张靖周,张靖周等.Modeled experiment on overall cooling effectiveness of effusion holes in front of outer liner of annular slinger combustor.Hangkong Dongli Xuebao,2017 [40] 张靖周,张靖周,张靖周等.Effects of blade shape on convective heat transfer induced by a piezoelectrically actuated vibrating fan.INTERNATIONAL JOURNAL OF THERMAL SCIENCES,2018