Gough, Tim - University of Bradford - Centre for Advanced Materials Engineering

个人简介

After graduating with a BEng (Hons) in Mechanical Engineering from the University of Surrey in 1991 I was employed on a research grant in aerodynamics. This led to the award of a PhD (part time) on the development of turbulent boundary layers and wakes in 1996. Following this I moved to the University of Bradford as a postdoctoral research engineer looking into the use of hydrocyclones for separations of yeast from beer and cider under the tutelage of Professor Martin Thew. After some time in industry as a contracting engineer developing cyclones for the offshore oil industry I returned to Bradford to join the IRC in Polymer Engineering where I was employed on the interdisciplinary and multi-university EPSRC grants 'Microscale Polymer Processing' and 'Enhanced Polymer Processing'. I was appointed as a lecturer in 2006, senior lecturer in 2011 and reader in 2015, am co-ordinator for rheo-optical and spectroscopic studies and sit on the Operations Committee of the broader IRC (see www.polymerirc.org.)

近期论文

查看导师最新文章（温馨提示：请注意重名现象，建议点开原文通过作者单位确认）

Wood C., Alwati A., Halsey S.A., Gough T. and Brown E.C. (2016): "Near infra red spectroscopy as a multivariate process analytical tool for predicting pharmaceutical co-crystal concentration." Journal of Pharmaceutical and Biomedical Analysis (accepted). Kelly A.L., Halsey S.A., Bottom R.A., Korde S. and Gough T. (2015): "A novel transflectance near infrared spectroscopy technique for monitoring hot melt extrusion" International Journal of Pharmaceutics, 496 (1): 117-123. Kulkarni C., Wood C., Kelly A.L., Gough T. and Paradkar A. (2015): "Stoichiometric control of co-crystal formation by solvent free continuous co-crystallization (SFCC)" Crystal Growth & Design, 15 (12): 5648-5651. Karandikar H., Ambardekar R., Kelly A.L., Gough T. and Paradkar A. (2015): "Systematic identification of thermal degradation products of HPMCP during hot melt extrusion process" International Journal of Pharmaceutics, 486 (1): 252-258. Vera-Sorroche J., Kelly A.L., Brown E.C., Gough T. and Abeykoon C. (2014): "The effect of melt viscosity on thermal efficiency for single screw extrusion of HDPE" Chemical Engineering Research and Design, 92 (11): 2404-2412. Heeley E.L., Gough T., Hughes D.J., Bras W. and Rieger J. (2013): "Effect of processing parameters on the morphology development during extrusion of polyethylene tape: An in-line small-angle X-ray scattering (SAXS) study" Polymer, 54 (24): 6580-6588. Ma Z., Fernandez-Ballester L., Cavallo D., Gough T. and Peters G.W. (2013): "High-stress shear-induced crystallization in isotactic polypropylene and propylene/ethylene random copolymers" Macromolecules, 46 (7): 2671-2680. Grant C.A., Al-Fouzan A., Gough T., Twigg P.C. and Coates P.D. (2013): "Nano-scale temperature dependent visco-elastic properties of polyethylene terephthalate (PET) using atomic force microscope (AFM)" Micron, 44 174-178. Kulkarni C., Kendrick J., Kelly A.L., Gough T. and Paradkar A. (2013): "Polymorphic transformation of artemisinin by high temperature extrusion" CrystEngComm, 15 (32): 6297-6300. Kulkarni C., Kelly A.L., Kendrick J., Gough T. and Paradkar A. (2013): "Mechanism for polymorphic transformation of artemisinin during high temperature extrusion" Crystal Growth & Design, 13 (12): 5157-5161. Kelly A.L., Gough T., Dhumal R.S., Halsey S.A. and Paradkar A. (2012): "Monitoring ibuprofen–nicotinamide cocrystal formation during solvent free continuous cocrystallization (SFCC) using near infrared spectroscopy as a PAT tool" International Journal of Pharmaceutics, 426 (1): 15-20. Chamberlain P., Drewello R., Korn L., Bauer W. and Gough T. (2011): "Construction of the Khoja Zaynuddin Mosque: Use of animal glue modified with urine" Archaeometry, 53 (4): 830-841. Tenchev R., Gough T., Harlen O.G., Jimack P.K. and Klein D.H. (2011): "Three dimensional finite element analysis of the flow of polymer melts" Journal of Non-Newtonian Fluid Mechanics, 166 (5): 307-320. Musil J., Zatloukal M., Gough T. and Martyn M.T. (2011): "Experimental investigation of die drool and slip-stick phenomena during hdpe polymer melt extrusion" Novel Trends In Rheology IV. Musil J., Zatloukal M., Gough T. and Martyn M.T. (2011): "Investigation of vortex development during polymer melt flows by flow birefringence" Novel Trends In Rheology IV. Soon C.F., Youseffi M., Gough T., Blagden N. and Denyer M.C. (2011): "Rheological characterization and in-situ investigation of the time-dependent cholesteric based lyotropic liquid crystals" Materials Science and Engineering: C, 31 (7): 1389-1397. Clarke N., De Luca E., Buxton G., Hutchings L.R. and Gough T. (2010): "Chain Deformation in Entangled Polymer Melts at Re-entrant Corners" Macromolecules, 43 (3): 1537-1542. Burton E.L., Woodhead M., Coates P.D. and Gough T. (2010): "Reactive grafting of glycidyl methacrylate onto polypropylene" Journal of Applied Polymer Science, 117 (5): 2707-2714. McLeish T.C., Clarke N., Hutchings L.R., Graham R.S. and Gough T. (2009): "Neutron flow-mapping: Multiscale modelling opens a new experimental window" Soft Matter, 5 (22): 4426-4432. Kelly A.L., Gough T., Whiteside B.R. and Coates P.D. (2009): "High shear strain rate rheometry of polymer melts" Journal of Applied Polymer Science, 114 (2): 864-873. Graham R.S., Bent J., Clarke N., Richards R.W and Gough T. (2009): "The long-chain dynamics in a model homopolymer blend under strong flow: Small-angle neutron scattering and theory" Soft Matter, 5 (12): 2383-2389. Fernandez-Ballester L., Gough T., Meneau F., Balta-Calleja F.J. and Kornfield J.A. (2008): "Simultaneous birefringence, small-and wide-angle X-ray scattering to detect precursors and characterize morphology development during flow-induced crystallization of polymers" Journal of synchrotron radiation, 15 (2): 185-190. Gough T., Spares R., Kelly A.L., Brook S.M. and Coates P.D. (2008): "Three-dimensional characterisation of full field stress and velocity fields for polyethylene melt through abrupt contraction" Plastics, Rubber and Composites, 37 (2-4): 158-165. Howse J.R., Jones R.A., Ryan A.J., Gough T. and Golestanian R. (2007): "Self-motile colloidal particles: from directed propulsion to random walk" Physical review letters, 99 (4): 048102. Bent J., Hutchings L.R., Richards R.W., Gough T. and McLeish T.C. (2003): "Neutron-mapping polymer flow: scattering, flow visualization, and molecular theory" Science, 301 (5640): 1691-1695.