近期论文
查看导师新发文章
（温馨提示：请注意重名现象，建议点开原文通过作者单位确认）
C. Gao, Z. Fang, L. Jin, X. Guan, J. He*, "Model averaging and probability of detection estimation under hierarchical uncertainties for Lamb wave detection", Mechanical Systems and Signal Processing, 2022, 165,108302.
X. Wang, Y. Zhao, L. Wang, L. Wei, J. He* and X. Guan*, "In-situ SEM investigation and modeling of small crack growth behavior of additively manufactured titanium alloy", International Journal of Fatigue, 2021, 149,106303.
J. He, M. Huang, W. Wang, S. Wang and X. Guan, "An asymptotic stochastic response surface approach to reliability assessment under multi-source heterogeneous uncertainties", Reliability Engineering & System Safety, 2021, 107804.
D. Zhou, J. He, Y. Du, C. Sun and X. Guan, "Probabilistic information fusion with point, moment and interval data in reliability assessment", Reliability Engineering & System Safety, 2021, 107790.
X. Duan, H. Yuan, W. Tang, J. He and X. Guan, "A Phenomenological Primary–Secondary–Tertiary Creep Model for Polymer-Bonded Composite Materials", 2021, Polymers, 2021, 13(14), 2353.
X Duan, H. Yuan, W. Tang, J. He and X. Guan, "A General Temperature-Dependent Stress–Strain Constitutive Model for Polymer-Bonded Composite Materials", Polymers, 2021, 13(9), 1393.
X. Wang, J. He, W. Guo and X. Guan, "Three-dimensional damage quantification of low velocity impact damage in thin composite plates using phased-array ultrasound", Ultrasonics, 2021, 110, 106264.
J.He, Z. Fang, J. Liu*, F. Gao and J. Lin, "Fatigue damage detection from imbalanced inspection data of Lamb wave", Structural Health Monitoring, 2020, 14759217211015243.
J. He, H. Huo, X. Guan*, J.Yang, "A Lamb wave quantification model for inclined cracks with experimental validation", Chinese Journal of Aeronautics, 2021,34(2): 601-611
Huo H, J He*, Guan X. "A Bayesian fusion method for composite damage identification using Lamb wave ". Structural Health Monitoring, 2020.
J. He, J. Chen, X. Guan, "Lifetime distribution selection for complete and censored multi-level testing data and its influence on probability of failure estimates". Struct Multidisc Optim, 2020, 62, 1-17.
C. Qian, Y. Ran, J. He*, "Application of artificial neural networks for quantitative damage detection in unidirectional composite structures based on Lamb waves". Advances in Mechanical Engineering, 2020. 12(3).
X. Guan, J. He, "Life time extension of turbine rotating components under risk constraints: A state-of-the-art review and case study", International Journal of Fatigue, 2019, 129
Y Cui, Y Chen, J. He*, "Equivalent initial flaw size model for fracture strength prediction of optical fibers with indentation flaws", Engineering Fracture Mechanics, 2019, 215: 36-48.
J. He, Y. Zhou, "A novel mode shape reconstruction method for damage diagnosis of cracked beam", Mechanical Systems and Signal Processing, 2019,122: 433-447.
X. Guan, J. He, "Uncertainty sensitivity analysis of damage tolerance evaluation with ultrasonic data", AIP Conference Proceedings 2102, 2019.
J. Chen, B. Diao, J. He*, S. Pang, X. Guan, "Equivalent surface defect model for fatigue life prediction of steel reinforcing bars with pitting corrosion", International Journal of Fatigue, 2018 110:153-161.
Wang D, He J*, Guan X, Yang J, Zhang W，"A model assessment method for predicting structural fatigue life using Lamb waves ", Ultrasonic,2018,84: 319-328.
W. Zhang, H. Liu, Q. Wang, and J. He*, "A Fatigue Life Prediction Method Based on Strain Intensity Factor", Materials, 2017, 10(7): 689
J. He, X.Guan, "Uncertainty Sensitivity Analysis for Reliability Problems with Parametric Distributions", IEEE Transactions on Reliability, 2017, 66(3):712-721.
J. He, Y. Ran, L. Bin, and X. Guan, "A Fatigue Crack Size Evaluation Method Based on Lamb Wave Simulation and Limited Experimental Data", Sensors, 2017, 17(9): 2097
F. Sun, N. Wang, J. He*, X. Guan, and J. Yang, "Lamb Wave Damage Quantification Using GA-Based LS-SVM", Materials, 2017, 10(6):648
X. Guan, Y. Wang, and J. He*, "A Probabilistic Damage Identification Method for Shear Structure Components Based on Cross-Entropy Optimizations", Entropy, 2017, 19(1):27
J. He, Y. Zhou, X. Guan, W. Zhang, Y. Wang and W. Zhang, "An integrated health monitoring method for structural fatigue life evaluation using limited sensor data", Materials, 2016, 9(11): 894
J. He, J. Yang, Y. Wang and H. Waisman, "Probabilistic modeling and sizing of hole-edge crack using Fiber Bragg Grating sensor and high-order extended finite element method ", Sensors, 2016, 16(11):1956
J. He, X. Guan and R. Jha, "Improve the accuracy of asymptotic approximation in reliability problems involving multi-modal distributions", IEEE Transactions on Reliability, 2016, 99:1-13
J. He, Y. Zhou, X. Guan, W. Zhang, W. Zhang and Y. Liu, "Time domain strain/stress reconstruction based on empirical mode decomposition: numerical study and experimental validation". Sensors, 2016, 16(8):1290.
J. Yang, J. He*, X. Guan, D. Wang, H. Cheng, W. Zhang and Y. Liu, "A probabilistic crack size quantification method using in-situ Lamb wave test and Bayesian updating", Mechanical Systems and Signal Processing, 2016, 78:118-133.
W Zhang, Z. Bao, S. Jiang and J. He. An Artificial Neural Network-Based Algorithm for Evaluation of Fatigue Crack Propagation Considering Nonlinear Damage Accumulation. Materials, 2016, 9(6): 483.
J. Shan, W. Zhang, J. He and Z. Wang, “Comparative study between crack closure model and Willenborg model for fatigue prediction under overload effects”, Chinese Journal of Aeronautics, 2016 (in press)
W. Zhang, Q. Wang, X. Li and J. He. A simple fatigue life prediction algorithm using the modified NASGRO equation, Mathematical Problems in Engineering, 2016:4298507
X. Fang, J. He*, and Y. Zhang, “Preparation and Characterization of Large-Area and Flexible Lead Zirconate Titanate/Polyvinyl-Butyral/Additives Composite Films for Piezoelectric Sensor Application”, Sensors and Materials, 2016, 28(6):681-688
M. Huang, J. He* and X. Guan, "Probabilistic inference of fatigue damage propagation with limited and partial information", Chinese Journal of Aeronautics, 2015, 28(4): 1055-1065.
Q. Tang, J. He*, X. Fang and W. Zhang, "Identification of Failure Mechanism Consistency for NBR Accelerated Test", Journal of Testing and Evaluation, 2016 44(1): 47-54.
Q. Tang, J. He* and W. Zhang, "Influencing Factors of Thermal Contact Conductance between TC4/30CrMnSi Interfaces", International Journal of Heat and Mass Transfer, 2015, 86:694-698.
D. Wang, J. He*, B. Dong, X. Liu and W. Zhang, “Novel Damage Detection Techniques for Structural Health Monitoring Using a Hybrid Sensor”, Mathematical Problems in Engineering, 2016, 3734258
X. Guan, J. He and E. Rasselkorde, "A time-domain synthetic aperture ultrasound imaging method for material flaw quantification with validations on small-scale artificial and natural flaws", Ultrasonics, 2015, 56:487-496.
T. Peng, J. He, Y. Xiang, Y. Liu, A. Saxena, J. Celaya and K. Goebel, "Probabilistic fatigue damage prognosis of lap joint using Bayesian updating", Journal of Intelligent Material Systems and Structures, 2014 (5): 1045389X14538328
X. Guan, J. He, E. Rasselkorde, J. Zhang, W. Abbasi and S. Zhou, "Probabilistic Fatigue Life Prediction and Structural Reliability Evaluation of Turbine Rotors Integrating an Automated Ultrasonic Inspection System", Journal of Nondestructive Evaluation, 2014 33(1):51-61
J. He, X. Guan, T. Peng, Y. Liu, A. Saxena, J. Celaya and K. Goebel, "A multi-feature integration method for fatigue crack detection and crack length estimation in riveted lap joints using Lamb waves", Smart Materials and Structures, 2013 22(10):105007.
J. He, X. Guan and Y. Liu, "Structural response reconstruction based on empirical mode decomposition in time domain", Mechanical Systems and Signal Processing, 2012 28:348-366
X. Guan, J. He, R. Jha and Y. Liu. "An efficient analytical Bayesian method for reliability and system response updating based on Laplace and inverse first-order reliability computations", Reliability Engineering & System Safety, 2012 97(1):1-13
J. He, Z. Lu and Y. Liu, "New method for concurrent dynamic analysis and fatigue damage prognosis of bridges", Journal of Bridge Engineering, 2011 17(3):396-408
J. Xie, J. He, Y. Zhang and M. Freda, "Determination of Acceleration Factor in Predicting the Field Life of Plated Through Holes from Thermal Stress Data", IEEE Transaction on Components and Packaging Technologies, 2008 3(31):634-641
京公网安备 11010802027423号