Transparent Conductive Layer Based on Oriented Platinum Networks,ChemistrySelect

当前位置： X-MOL 学术 › ChemistrySelect › 论文详情

Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)

Transparent Conductive Layer Based on Oriented Platinum Networks
ChemistrySelect ( IF 1.9 ) Pub Date : 2019-12-11 , DOI: 10.1002/slct.201904293
Irek Nizameev _{1,

2} , Guliya Nizameeva ₂ , Marsil Kadirov _{1,

2}

Affiliation

The paper proposes an original method of creating a transparent electrically conductive coating based on oriented networks of platinum nanowires. Platinum nanowires are obtained by chemical precipitation from the liquid phase using the micellar template of cetyltrimethylammonium bromide (CTAB) as a form‐creating and orienting component. The deposition of networks is made on the glass, using a small amount of platinum. Platinum nanowires with a height of 3–6 nm have a width of 50–60 nm, which corresponds in shape to a tape or a strip. The ratio of the length of the stripes to the width is about 500: 1. The aspect ratio of length to width is about 500:1. The orientation of the bands is high, and the density on the glass surface is low. This fact contributes to obtaining high optical transparency of the layer with a small value of the surface resistance of the coating.

中文翻译：

基于定向铂金网络的透明导电层

本文提出了一种基于铂纳米线定向网络创建透明导电涂层的原始方法。铂纳米线是通过使用十六烷基三甲基溴化铵（CTAB）的胶束模板作为形成和定向组分从液相化学沉淀获得的。使用少量的铂在玻璃上沉积网络。高度为3–6 nm的铂纳米线的宽度为50–60 nm，其形状与带子或条带相对应。条纹的长度与宽度的比率为大约500：1。长度与宽度的纵横比为大约500：1。带的取向高，并且玻璃表面上的密度低。

更新日期：2019-12-11

点击分享查看原文

点击收藏

阅读更多本刊新发论文本刊介绍/投稿指南