重铬酸盐氧化剂测定化学需氧量的三步化学发光法,Analytical Methods

当前位置： X-MOL 学术 › Anal. Methods › 论文详情

Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)

重铬酸盐氧化剂测定化学需氧量的三步化学发光法
Analytical Methods ( IF 2.7 ) Pub Date : 2017-09-19 00:00:00 , DOI: 10.1039/c7ay01652b
Do Thi Kim Hue _{1,

2,

3,

4,

5} , Takumi Shiba _{3,

4,

5,

6,

7} , Yasuaki Maeda _{3,

4,

5,

8} , Norimichi Takenaka _{1,

2,

3,

4,

5}

Affiliation

本研究基于高锰酸盐化学需氧量（COD _Mn）方法（JIS K0102）的原理，开发了在三步化学发光（CL）化学需氧量（COD）方法中使用重铬酸钾作为氧化剂的方法。（3步CL COD _Cr方法）。样品在加热下与过量的重铬酸盐反应，剩余的重铬酸盐被还原性有机化合物中和。然后，使用高锰酸盐CL试剂在CL检测器中检测还原性有机化合物的残留量。六种有机化合物-没食子酸，苯酚，邻苯二酚，抗坏血酸，邻苯三酚和邻苯二甲酸氢钾被研究为还原性有机化合物。研究了这些化合物与酸性高锰酸盐试剂的CL动力学，并以邻苯三酚显示了最高的信号和最快的相关响应。因此，选择了邻苯三酚作为还原性有机化合物。七种金属离子（Cr（III），Mn（II），Cu（II），Ag（I）的增强作用），Fe（II），Fe（III）和Mg（II）–进行了研究。结果表明，Cr（III），Mn（II），Fe（II）和Fe（III）增强了信号。Fe（II）和Fe（III）表现出最高的增强效果，其中信号分别增加到188％和205％。然而，由于Fe（II）与高锰酸盐之间的反应，Fe（II）使高锰酸盐试剂变得较不稳定，并且增强作用随时间显着降低。因此，将Fe（III）以0.45 mmol dm的最佳浓度添加到高锰酸盐试剂中⁻³。对于几种有机化合物，三步CL COD_Cr方法与常规COD_Mn之间的相关性表明，良好的测定系数R ² = 0.9594（ n = 16）。以没食子酸为标准，检测下限为0.083 mg L^-1。将该方法应用于河流水样的测定，得到的结果与COD_Mn法具有很好的相关性。

"点击查看英文标题和摘要"

A 3-step chemiluminescence method for chemical oxygen demand measurement with dichromate oxidizing reagent

In this study, the use of potassium dichromate as an oxidizing reagent in the 3-step chemiluminescence (CL) chemical oxygen demand (COD) method, based on the principle of the permanganate COD (COD_Mn) method (JIS K0102), was developed (3-step CL COD_Cr method). The sample reacted with an excess of dichromate under heating, and the remaining dichromate was neutralized by a reducing organic compound. Then, the remaining amount of the reducing organic compound was detected in the CL detector using permanganate CL reagent. Six organic compounds – gallic acid, phenol, pyrocatechol, ascorbic acid, pyrogallol, and potassium hydrogen phthalate – were investigated as the reducing organic compounds. The CL kinetics of these compounds with acidic permanganate reagent were studied, and pyrogallol showed the highest signal with the fastest relevant response. Hence, pyrogallol was chosen as the reducing organic compound. The enhancement effects of seven metal ions – Cr(III), Mn(II), Cu(II), Ag(I), Fe(II), Fe(III), and Mg(II) – were investigated. The results showed that Cr(III), Mn(II), Fe(II), and Fe(III) enhanced the signal. Fe(II) and Fe(III) showed the highest enhancement effects, in which the signals increased to 188% and 205%, respectively. However, Fe(II) made the permanganate reagent become less stable due to the reaction between Fe(II) and permanganate and the enhancement decreased significantly with time. Hence, Fe(III) was added to the permanganate reagent at the optimum concentration of 0.45 mmol dm⁻³. The correlation between the 3-step CL COD_Cr method and the conventional COD_Mn for several organic compounds showed a good determination coefficient R² = 0.9594 (n = 16). The limit of detection was 0.083 mg L⁻¹, using gallic acid as a standard. The method was applied to measurement of river water samples, obtaining results in good correlation with the COD_Mn method.

更新日期：2017-10-12

点击分享查看原文

点击收藏

阅读更多本刊新发论文本刊介绍/投稿指南